Search results
Results from the WOW.Com Content Network
8.2/8.5 A-A-59439, ISO 6150B 030 430 30 20/30 H US Industrial 3/8" HP 8 ISO 6150C 170.08 381 84 ARO 310 9 014.09 40 AA Scandinavian 9.5/10 9.5/10 032.10 408 32/1800 Eurostandard 10 10 027 410 27 Schrader 1/2" 017.10 TL US Industrial 1/2" 11 A-A-59439, ISO 6150B 037 550 37 20/30 G US Industrial 1/2" HP 11 ISO 6150C 170.11 471
a 1-1/2 inch bore would be coded as a size number 3 (Base number 1 + 2 for the two 1/4 inches over 1 inch), and so on up to a size 18 (Base number 1 + 17 for the seventeen 1/4 inch increments over the 1 inch base). Lastly, 3/16 inch is added to the coded size for the actual finished bore diameter.
A 37° flare type end fitting for flexible hose The AN thread (also A-N ) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.
JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved. The SAE J514 standard replaces the MS16142 US military specification , although some tooling is still listed under MS16142.
Two-barrel downdraft Holley 2280 carburetor Cross-sectional schematic. A carburetor (also spelled carburettor or carburetter) [1] [2] [3] is a device used by a gasoline internal combustion engine to control and mix air and fuel entering the engine. [4]
POL is the common name for the standard CGA 510 (US Compressed Gas Association connection number). The Thread specification is .885" – 14 NGO – LH – INT, meaning 0.885 in (22.5 mm) diameter thread, 14 threads per inch (1.814 mm pitch), National Gas Outlet form, left-hand internal thread. [3]
The copper crush washer in the gap between the fitting and body of the caliper completes the seal. Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids damage that can be caused by twisting the hose during installation.
The 253 was initially only available with a 2-barrel carburettor while the 308 was only ever available with a 4-barrel carburettor (except for when it was used in Bedford trucks in the late 70's). [2] Once the Canadian 307ci engines were used up the 308 became available across all models in the HT range, including the 2-door Monaro coupe. At ...