Search results
Results from the WOW.Com Content Network
Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. [1] Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and ...
This circuit diagram shows the interconnections of parts for a very basic preselector which goes between and antenna and a radio. Source Drawn using free software by me using a well known circuit Date 2014-10-29 Author JNRSTANLEY. Permission (Reusing this file) See below.
By 1977, all of Crown's tape recorder products had been phased out. [2] In 1979, Crown introduced the PSA-2 & SA-2 power amplifiers with analog computer control of transistor performance to maximize output characteristics. [2] The FM-1 stereo radio tuner was praised at the Consumer Electronics Show. [2] In 1981, the FM-2 with digital tuning was ...
Neutrik Speakon. The connector barrels are 26 millimetres (1.024 in) overall diameter. [1] Speakon panel connectors (center) provided on a professional PA power amplifier by QSC with a power output of 2 x 700 Watt (4 Ohm) The Speakon (stylized speakON) is a trademarked name for an electrical connector, [2] originally manufactured by Neutrik ...
Older models that used tube power amplifiers use a variety of six-pin connectors, while later models use nine-pin connectors. [20] In all cases, for a single organ – Leslie configuration, the mains power , audio and control signals are all carried on the connector, and the design of the pin layouts varies between organs and speakers.
The decibel unloaded reference voltage, 0 dBu, is the AC voltage required to produce 1 mW of power across a 600 Ω impedance (approximately 0.7746 V RMS). [2] This awkward unit is a holdover from the early telephone standards, which used 600 Ω sources and loads, and measured dissipated power in decibel-milliwatts ( dBm ).
XLR3 cable connectors female (left) and male. The XLR connector is a type of electrical connector primarily used in professional audio, video, and stage lighting equipment. XLR connectors are cylindrical, with three to seven connector pins, and are often employed for analog balanced audio interconnections, AES3 digital audio, portable intercom, DMX512 lighting control, and for low-voltage ...
A microphone preamplifier is a sound engineering device that prepares a microphone signal to be processed by other equipment. Microphone signals are often too weak to be transmitted to units such as mixing consoles and recording devices with adequate quality.