Search results
Results from the WOW.Com Content Network
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate; Pages for logged out editors learn more
Charge control is a technology that lets an electric utility control, in real time, the charging of a gridable (plug-in) vehicle, such as a plug-in hybrid (PHEV) or a battery electric vehicle (BEV). Through charge control, the utility is able to postpone charging of the vehicle during time of peak demand .
By way of example, a 150 volt PV array connected to an MPPT charge controller can be used to charge a 24 or 48 volt battery. Higher array voltage means lower array current, so the savings in wiring costs can more than pay for the controller. [citation needed] Charge controllers may also monitor battery temperature to prevent overheating.
Electronic controllers add greater flexibility in management of boost pressures, compared with the manual controllers. [2] The actuation of an electronic boost controller can be managed by one of two control systems: Open-loop is the simpler option, where control output is merely based on other inputs such as throttle angle and/or engine speed ...
The engine has three turbos, with the electric "turbo" driving the exhaust turbines of the twin-turbo. [7] Despite initial reports that the Volvo XC90 T6 would have a related improvement, [ 8 ] only the 2016 Volvo XC90 T8 actually received a Twin Engine starter-generator-supercharger in addition to the mechanical twincharger arrangement.
The charge control consists of a pressure switch built into the cell, which disconnects the charging current when the internal cell pressure rises above a certain limit; usually 200 pounds per square inch (1.4 MPa) to 300 pounds per square inch (2.1 MPa). This prevents overcharging and damage to the cell.
Variable Speed Fire Pump Controllers were invented and released with a UL Listing for fire pump service in 2003 by Master Control Systems, Inc. [1] [2] Paragraph 10.5.5 in the 2003 edition of NFPA-20 recognized Variable Speed as an accepted method for operating the fire pump. Then in the NFPA-20 2007 edition, section 10.10 was added to clarify ...
1973: The next mass-produced turbocharged car was the BMW 2002 Turbo, introduced at the 1973 Frankfurt motor show and featuring a 2.0 L (120 cu in) four-cylinder engine. [10] Due to excessive turbo lag, safety concerns and the 1973/1974 oil crisis, the 2002 Turbo was discontinued in 1974. [10]