Search results
Results from the WOW.Com Content Network
Automobile tire damaged after an impact. A blowout (also known as a burst) is a rapid, explosive loss of inflation pressure of a pneumatic tire.. The primary cause for a blowout is encountering an object that cuts or tears the structural components of the tire to the point where the structure is incapable of containing the compressed air, with the escaping air adding to further tear through ...
Tire load sensitivity describes the behaviour of tires under load. Conventional pneumatic tires do not behave as classical friction theory would suggest. The load sensitivity of most real tires in their typical operating range is such that the coefficient of friction decreases as the vertical load, Fz, increases.
A tire-pressure monitoring system (TPMS) monitors the air pressure inside the pneumatic tires on vehicles. [1] A TPMS reports real-time tire-pressure information to the driver, using either a gauge, a pictogram display, or a simple low-pressure warning light. TPMS can be divided into two different types – direct (dTPMS) and indirect (iTPMS).
A 2001 NHTSA study found that 40% of passenger cars have at least one tire under-inflated by 0.4 bars (6 psi) or more. [1] The number one cause of tire failure was determined to be under-inflation. Drivers are encouraged to make sure their tires are adequately inflated at all times.
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
[[Category:Tire manufacturer templates]] to the <includeonly> section at the bottom of that page. Otherwise, add <noinclude>[[Category:Tire manufacturer templates]]</noinclude> to the end of the template code, making sure it starts on the same line as the code's last character.
Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction. The UTQG was created by the National Highway Traffic Safety Administration in 1978, a branch of the United States Department of Transportation (DOT). [ 1 ]
Tire balance measurement is a test where the tire is automatically placed on wheel halves, rotated at a high speed and measured for imbalance. Large commercial truck/bus tires, as well as some passenger and light truck tires, are inspected by X-ray or magnetic induction based inspection machines, that can penetrate the rubber to analyze the ...