Search results
Results from the WOW.Com Content Network
Once the engine spins to starting speed, centrifugal force causes the lever to move out of the way, and the exhaust valve is allowed to seat fully. [4] Older compression release systems used a small bump on the cam that would bump the valve very slightly at low speeds. Once the engine gained speed, the pressure would push the exhaust valve ...
A diaphragm pump (also known as a Membrane pump) is a positive displacement pump that uses a combination of the reciprocating action of a rubber, thermoplastic or teflon diaphragm and suitable valves on either side of the diaphragm (check valve, butterfly valves, flap valves, or any other form of shut-off valves) to pump a fluid.
The oldest engine technological predecessor for the variable-displacement engine is the hit and miss engine, developed in the late 19th century.These single-cylinder stationary engines had a centrifugal governor that cut the cylinder out of operation so long as the engine was operating above a set speed, typically by holding the exhaust valve open.
In theory, the closing of all rear bank valves produces an ‘air spring’ effect. However, the reciprocating effect of the piston with closed valves reportedly produces a vacuum condition where oil can get pulled past the piston rings to flood the cylinder. When VCM disengages, the engine then misfires if needing to clear the cylinder of oil.
In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.
A blowoff valve is designed to release pressure in the intake system when the throttle is closed. A "recirculating" type blowoff valve releases the pressurised air back into the non-pressurized section of the intake (i.e. upstream of the turbocharger), while an "atmospheric venting" type blowoff valve dumps the air directly into the atmosphere.
Pneumatic valve springs are also found in several Moto GP motorcycle engines, debuting in 2002 with the Aprilia RS Cube. In 2005, Team Roberts was the first to use pneumatic valves full-time in their uncompetitive KTM powered bike. Today, almost all of the MotoGP teams use pneumatic valve technology on their bikes, including Yamaha, Suzuki and ...
There are many systems for VVT, which involve changing either the relative timing, duration or opening of the engine's inlet and exhaust valves. One of the first practical VVT systems used a variator to change the phase [note 1] of the camshaft and valves. This simple system cannot change the duration of the valve opening, or their lift.