enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...

3. Resin casting - Wikipedia

   en.wikipedia.org/wiki/Resin_casting

   The molds are commonly half-divided (like the hollowed chocolate Easter eggs with candy inside) and a release agent may be used to make removal of the hardened/set resin from the mold easier. The hardened resin casting is removed from the flexible mold and allowed to cool. A Baldwin 6-axle locomotive kit cast in resin in HO Scale

4. Molding (process) - Wikipedia

   en.wikipedia.org/wiki/Molding_(process)

   A mold or mould is a hollowed-out block that is filled with a liquid or pliable material such as plastic, glass, metal, or ceramic raw material. [2] The liquid hardens or sets inside the mold, adopting its shape. A mold is a counterpart to a cast. The very common bi-valve molding process uses two molds, one for each half of the object.

5. Slip casting - Wikipedia

   en.wikipedia.org/wiki/Slip_casting

   Slip casting, or slipcasting, is a ceramic forming technique, and is widely used in industry and by craft potters to make ceramic forms. This technique is typically used to form complicated shapes like figurative ceramics that would be difficult to be reproduced by hand or other forming techniques. [ 1 ]

6. RTV silicone - Wikipedia

   en.wikipedia.org/wiki/RTV_silicone

   Silicones also exhibit good chemical resistance and high-temperature resistance (205 °C, 400 °F and higher). For this reason, silicone molds are suitable for casting low-melt metals and alloys (e.g. zinc, tin, pewter, and Wood's metal). RTV silicone rubbers are, however, generally expensive – especially platinum-cure.

7. Spin casting - Wikipedia

   en.wikipedia.org/wiki/Spin_casting

   The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty .