Search results
Results from the WOW.Com Content Network
Dual-ported RAM (DPRAM), also called dual-port RAM, is a type of random-access memory (RAM) that can be accessed via two different buses.. A simple dual-port RAM may allow only read access through one of the ports and write access through the other, in which case the same memory location cannot be accessed simultaneously through the ports since a write operation modifies the data and therefore ...
Dual-ported video RAM (VRAM) is a dual-ported RAM variant of dynamic RAM (DRAM), which was once commonly used to store the Framebuffer in Graphics card, . Dual-ported RAM allows the CPU to read and write data to memory as if it were a conventional DRAM chip, while adding a second port that reads out data.
One should definitely be careful buying 1 GB memory modules, because all these variations can be sold under one price position without stating whether they are ×4 or ×8, single- or dual-ranked. There is a common belief that number of module ranks equals number of sides.
Dual-channel memory slots, color-coded orange and yellow for this particular motherboard. Dual-channel-enabled memory controllers in a PC system architecture use two 64-bit data channels. Dual-channel should not be confused with double data rate (DDR), in which data exchange happens twice per DRAM clock. The two technologies are independent of ...
It adds functions such as bit masking (writing to a specified bit plane without affecting the others) and block write (filling a block of memory with a single colour). Unlike VRAM and WRAM, SGRAM is single-ported. However, it can open two memory pages at once, which simulates the dual-port nature of other video RAM technologies.
The lower memory clock frequency may also enable power reductions in applications that do not require the highest available data rates. According to JEDEC [ 5 ] the maximum recommended voltage is 1.9 volts and should be considered the absolute maximum when memory stability is an issue (such as in servers or other mission critical devices).
PC-800 RDRAM operated at 400 MHz and delivered 1600 MB/s of bandwidth over a 16-bit bus. It was packaged as a 184-pin RIMM (Rambus in-line memory module) form factor, similar to a DIMM (dual in-line memory module). Data is transferred on both the rising and falling edges of the clock signal, a technique known as DDR. To emphasize the advantages ...
A memory bank is a part of cache memory that is addressed consecutively in the total set of memory banks, i.e., when data item a(n) is stored in bank b, data item a(n + 1) is stored in bank b + 1. Cache memory is divided in banks to evade the effects of the bank cycle time (see above) [=> missing "bank cycle" definition, above]. When data is ...