Search results
Results from the WOW.Com Content Network
A male D-subminiature connector used for an RS-232 serial port on an IBM PC compatible computer along with the serial port symbol. A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1]
Display Data Channel (DDC) is a collection of protocols for digital communication between a computer display and a graphics adapter that enable the display to communicate its supported display modes to the adapter and that enable the computer host to adjust monitor parameters, such as brightness and contrast.
The Arduino software includes a serial monitor which allows simple textual data to be sent to and from the Arduino board. The RX and TX LEDs on the board flash when data is being transmitted via the FTDI chip and the USB connection to the computer (but not for serial communication on pins 0 and 1).
The EDID is often stored in the monitor in the firmware chip called serial EEPROM (electrically erasable programmable read-only memory) and is accessible via the I²C-bus at address 0x50. The EDID PROM can often be read by the host PC even if the display itself is turned off.
An embedded system on a plug-in card with processor, memory, power supply, and external interfaces. An embedded system is a specialized computer system—a combination of a computer processor, computer memory, and input/output peripheral devices—that has a dedicated function within a larger mechanical or electronic system.
Each device internally uses a shift register for serial communication, which together forms an inter-chip circular buffer. Sub devices should use tri-state outputs so their MISO signal becomes high impedance (electrically disconnected) when the device is not selected. Subs without tri-state outputs cannot share a MISO line with other subs ...
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.