Search results
Results from the WOW.Com Content Network
In mechanical engineering, backlash, sometimes called lash, play, or slop, is a clearance or lost motion in a mechanism caused by gaps between the parts. It can be defined as "the maximum distance or angle through which any part of a mechanical system may be moved in one direction without applying appreciable force or motion to the next part in mechanical sequence."
The worm drive or "endless screw" was invented by either Archytas of Tarentum, Apollonius of Perga, or Archimedes, the last one being the most probable author. [1] The worm drive later appeared in the Indian subcontinent , for use in roller cotton gins , during the Delhi Sultanate in the thirteenth or fourteenth centuries.
The reversing rod, which connects to the valve gear, is attached to the lever either above or below the pivot in an alignment that gives good leverage. A square pin is arranged to engage with notches cut in the plates and holds the lever (and valve gear) in the desired position when the trigger is released.
Left-handed screw threads are also used in some other applications: Where the rotation of a shaft would cause a conventional right-handed nut to loosen rather than to tighten due to fretting induced precession. Examples include: The left hand pedal on a bicycle. [21] [23] The left-hand screw holding a circular saw blade or a bench grinder wheel on.
A knuckle joint on a locomotive, seen behind the pin joint of the eccentric crank. Ball-point pen included for size. A mechanical joint is a section of a machine which is used to connect one or more mechanical parts to another. Mechanical joints may be temporary or permanent; most types are designed to be disassembled.
The follower arm, which is the link that connects the crank arm to the slider, connects to a pin in the center of sliding object. This pin is considered to be on the linear movement axis. Therefore, to be considered an in-line crank slider, the pivot point of the crank arm must be in-line with this pin point.
A return connecting rod, [1] [2] return piston rod [i] or (in marine parlance) double piston rod engine [2] or back-acting engine is a particular layout for a steam engine. The key attribute of this layout is that the piston rod emerges from the cylinder to the crosshead, but the connecting rod then reverses direction and goes backwards to the ...
A cotter is a pin or wedge with a flat bearing surface passing through a hole to fix parts tightly together. In British usage cotter pin has the same meaning, [1] but in the U.S. it means a split pin. Typical applications are in fixing a crank to its crankshaft, as in a bicycle, and a piston rod to a crosshead, as in a steam engine. The angle ...