Search results
Results from the WOW.Com Content Network
Packet Tracer is commonly used by NetAcad students, since it is available to download after creating a free account. [10] However, due to functional limitations, it is intended by Cisco to be used only as a learning aid, not a replacement for Cisco routers and switches . [ 9 ]
In non-promiscuous mode, when a NIC receives a frame, it drops it unless the frame is addressed to that NIC's MAC address or is a broadcast or multicast addressed frame. In promiscuous mode, however, the NIC allows all frames through, thus allowing the computer to read frames intended for other machines or network devices.
On a lower-speed 1.544 Mbit/s T1 line, the same packet would take up to 7.8 milliseconds. A queuing delay induced by several such data packets might exceed the figure of 7.8 ms several times over. A queuing delay induced by several such data packets might exceed the figure of 7.8 ms several times over.
The port will not send out DTP frames or be affected by any incoming DTP frames. If you want to set a trunk between two switches when DTP is disabled, you must manually configure trunking using the (switchport mode trunk) command on both sides. The configured switch port mode setting is referred to as the port's trunking administrative mode.
The packet transmission time in seconds can be obtained from the packet size in bit and the bit rate in bit/s as: Packet transmission time = Packet size / Bit rate. Example: Assuming 100 Mbit/s Ethernet, and the maximum packet size of 1526 bytes, results in Maximum packet transmission time = 1526×8 bit / (100 × 10 6 bit/s) ≈ 122 μs
Davies, in his 1966 paper on packet switching, [26] applied Kleinorck's techniques to show that "there is an ample margin between the estimated performance of the [packet-switched] system and the stated requirement" in terms of a satisfactory response time for a human user. [65]
When an unlabeled packet enters the ingress router and needs to be passed on to an MPLS tunnel, the router first determines the forwarding equivalence class (FEC) for the packet and then inserts one or more labels in the packet's newly created MPLS header. The packet is then passed on to the next hop router for this tunnel. From an OSI model ...
Packet capture is the process of intercepting and logging traffic. As data streams flow across the network, the analyzer captures each packet and, if needed, decodes the packet's raw data, showing the values of various fields in the packet, and analyzes its content according to the appropriate RFC or other specifications.