Search results
Results from the WOW.Com Content Network
Standing rigging comprises the fixed lines, wires, or rods, which support each mast or bowsprit on a sailing vessel and reinforce those spars against wind loads transferred from the sails. This term is used in contrast to running rigging , which represents the moveable elements of rigging which adjust the position and shape of the sails.
A stay is part of the standing rigging and is used to hold a mast upright. It is a large strong rope, wire or rod extending from the upper end of each mast and running down towards the deck of the vessel in a midships fore -and- aft direction.
Rigging comprises the system of ropes, cables and chains, which support and control a sailing ship or sail boat's masts and sails. Standing rigging is the fixed rigging that supports masts including shrouds and stays. Running rigging is rigging which adjusts the position of the vessel's sails and spars including halyards, braces, sheets and ...
On a sailing boat, the shrouds are pieces of standing rigging which hold the mast up from side to side. There is frequently more than one shroud on each side of the boat. Usually a shroud will connect at the top of the mast, and additional shrouds might connect partway down the mast, depending on the design of the boat.
A backstay is a piece of standing rigging on a sailing vessel that runs from the mast to either its transom or rear quarter, counteracting the forestay and jib. It is an important sail trim control and has a direct effect on the shape of the mainsail and the headsail .
A diagram of the three spars and some of the rigging that can make up a bow: A.) Bowsprit, B.) Jibboom, C.) Flying jib-boom, D.) Jibstay. ... In yachts it is a boom ...
Gunter rigged Lobster 12.5. Gunter rig is a configuration of sail and spars used in sailing. It is a fore and aft sail set abaft (behind) the mast. The lower half of the luff (front) of the sail is attached to the mast, and the upper half is fastened to a spar which is approximately vertical and reaches above the top of the mast.
A sail plan is a drawing of a sailing craft, viewed from the side, depicting its sails, the spars that carry them and some of the rigging that supports the rig. [1] By extension, "sail plan" describes the arrangement of sails on a craft. [2] [3] A sailing craft may be waterborne (a ship or boat), an iceboat, or a sail-powered land vehicle.