Search results
Results from the WOW.Com Content Network
A voltage tester with three lamps to give an approximate indication of voltage magnitude. The test light is an electric lamp connected with one or two insulated wire leads. [1] Often, it takes the form of a screwdriver with the lamp connected between the tip of the screwdriver and a single lead that projects out the back of the screwdriver. By ...
Model-based voltage and current systems (MBVI systems): This is a technique that makes use of the information available from the current and voltage signals across all three phases simultaneously. Model-based systems are able to identify many of the same phenomena also seen by more conventional techniques, covering electrical, mechanical, and ...
Warren Seymour Johnson - Portrait courtesy of Johnson Controls corporate archives. Warren Seymour Johnson (November 6, 1847 – December 5, 1911) was an American college professor who was frustrated by his inability to regulate individual classroom temperatures.
A multimeter can use many different test probes to connect to the circuit or device under test. Crocodile clips, retractable hook clips, and pointed probes are the three most common types. Tweezer probes are used for closely spaced test points, as for instance surface-mount devices. The connectors are attached to flexible, well insulated leads ...
In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost over other protection methods. Areas with dangerous concentrations of flammable gases or dust are found in applications such as petrochemical refineries and mines.
Sensors measuring the paper quality (online meters) are attached to a sensor platform that move across the web guided by the scanner beam. A typical crossing time for a sensor platform is 10–30 s (an 8 m web, 60 cm/s). The sensor platform scans across the paper web and continuously measures paper characteristics from edge to edge.
Temperature measuring and controlling module for microcontroller experiment. Temperature control is a process in which change of temperature of a space (and objects collectively there within), or of a substance, is measured or otherwise detected, and the passage of heat energy into or out of the space or substance is adjusted to achieve a desired temperature.
Later model testers that are battery powered are limited to doing the "screen test". Older mains powered units can do all tests. The purpose of the high current test is to simulate a fault condition: if a live part contacts the earthed metalwork, the earth conductor should be able to carry sufficient current to blow the fuse and render the ...