Search results
Results from the WOW.Com Content Network
For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
E.214 provides a method to convert the IMSI into a number that can be used for routing to international SS7 switches. E.214 can be interpreted as implying that there are two separate stages of conversion; first determine the MCC and convert to E.164 country calling code then determine MNC and convert to national network code for the carrier's ...
From 1.0 through 2.95 mm, sizes are defined as follows, where N is an integer from 10 through 29: N · 0.1 mm; N · 0.1 + 0.05 mm; From 3.0 through 13.9 mm, sizes are defined as follows, where N is an integer from 30 through 139: N · 0.1 mm; From 14.0 through 25.0 mm, sizes are defined as follows, where M is an integer from 14 through 25: M ...
In mobile telecommunications network routing, E.214 is one of three prevailing numbering plans used for delivering mobility management related messages. [1]The E.164 numbering plan, which is a maximum of 15 digits and usually written with a "+" prefix, is the historic first-generation format representing the phone number.
The Short Message Service is realised by the use of the Mobile Application Part (MAP) of the SS7 protocol, with Short Message protocol elements being transported across the network as fields within the MAP messages. [1]
An SS7 probe is a physical device to obtain signalling and/or bearer information from a telecommunications network, such as the PSTN or a corporate telephone system. The probe passively monitors the E1 / T1 or SDH / SONET bearer channels, and extracts the signalling information for onward presentation to an application.
In the United States, the alcohol industry switched to metric bottle sizes on October 1, 1976, abandoning the existing 38 sizes of bottles and instead adopting the following 6 sizes: [2] 50 mL (miniature) 200 mL (replaced the half-pint) (≈237 mL is a U.S. half-pint) 500 mL (replaced the pint) (≈473 mL is a U.S. pint)