Search results
Results from the WOW.Com Content Network
x86 word, minimum size of short and int in C −32,768 to +32,767 0 to 65,535 4 bytes 32 bits x86 double word, minimum size of long in C, actual size of int for most modern C compilers, [8] pointer for IA-32-compatible processors −2,147,483,648 to +2,147,483,647 0 to 4,294,967,295 8 bytes 64 bits
A pointer a pointing to the memory address associated with a variable b, i.e., a contains the memory address 1008 of the variable b.In this diagram, the computing architecture uses the same address space and data primitive for both pointers and non-pointers; this need should not be the case.
Pushes current base pointer onto the stack, so it can be restored later. Value of base pointer is set to the address of stack pointer (which is pointed to the top of the stack) so that the base pointer will point to the top of the stack. Moves the stack pointer further by decreasing or increasing its value, depending on whether the stack grows ...
Each can be accessed as two separate bytes (thus BX's high byte can be accessed as BH and low byte as BL). Two pointer registers have special roles: SP (stack pointer) points to the "top" of the stack, and BP (base pointer) is often used to point at some other place in the stack, typically above the local variables (see frame pointer).
Front panel of an IBM 701 computer introduced in 1952. Lights in the middle display the contents of various registers. The instruction counter is at the lower left.. The program counter (PC), [1] commonly called the instruction pointer (IP) in Intel x86 and Itanium microprocessors, and sometimes called the instruction address register (IAR), [2] [1] the instruction counter, [3] or just part of ...
Pointer formats are known as near, far, or huge. Near pointers are 16-bit offsets within the reference segment, i.e. DS for data and CS for code. They are the fastest pointers, but are limited to point to 64 KB of memory (to the associated segment of the data type). Near pointers can be held in registers (typically SI and DI).
The x86-64 architecture does not use segmentation in long mode (64-bit mode). Four of the segment registers, CS, SS, DS, and ES, are forced to base address 0, and the limit to 2 64. The segment registers FS and GS can still have a nonzero base address. This allows operating systems to use these segments for special purposes.
SS:SP (SS is Stack Segment, SP is Stack Pointer) points to the address of the top of the stack, i.e. the most recently pushed byte. SS:BP (SS is Stack Segment, BP is Stack Frame Pointer) points to the address of the top of the stack frame, i.e. the base of the data area in the call stack for the currently active subprogram.