Ad
related to: how to join wood edge strips on concrete patio tile
Search results
Results from the WOW.Com Content Network
The effect of wood shrinkage is concealed when the joint is beaded or otherwise moulded. [1] In expensive cabinet work, glued dovetail and multiple tongue and groove are used. Each piece has a slot (the groove or dado) cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. The tongue projects a little less than the ...
Underside of a groin vault showing the arris. In architecture, an arris is the sharp edge formed by the intersection of two surfaces, such as the corner of a masonry unit; [1] the edge of a timber in timber framing; the junction between two planes of plaster or any intersection of divergent architectural details.
Bullnose trim is used to provide a smooth, rounded edge for countertops, staircase steps, building corners, verandas, or other construction.Masonry units such as bricks, concrete masonry units or structural glazed facing tiles may be ordered from manufacturers with square or bullnosed corners.
Normally, the desired outcome of jointing is an edge which is straight along its length and perpendicular to the face of the board. However, there is another technique often used when gluing up panels, referred to as a sprung joint. [1] In this technique, the desired outcome is an edge which is slightly concave along its length.
A biscuit joiner or biscuit jointer (or sometimes plate joiner) is a woodworking tool used to join two pieces of wood together. A biscuit joiner uses a small circular saw blade to cut a crescent-shaped hole (called the mouth) in the opposite edges of two pieces of wood or wood composite panels.
A joint replacing mortar with elastomeric sealant will absorb the compressive forces without damage. [4] Concrete decking (most typically in sidewalks) can suffer similar horizontal issues, which is usually relieved by adding a wooden spacer between the slabs. The wooden expansion joint compresses as the concrete expands.
Butt joint. A butt joint is a wood joint in which the end of a piece of material is simply placed (or “butted”) against another piece. The butt joint is the simplest joint. An unreinforced butt joint is also the weakest joint, as it provides a limited surface area for gluing and lacks any mechanical interlocking to resist external forces. [1]
Butt joint: The end of a piece of wood is butted against another piece of wood. This is the simplest and weakest joint. Of those, there is the a) T-butt, b) end-to-end butt, c) Miter butt and d) edge-to-edge butt. Lap joint: The end of a piece of wood is laid over and connected to another piece of wood.
Ad
related to: how to join wood edge strips on concrete patio tile