enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Such an appropriately sized drill is called a tap drill for that size of thread, because it is a correct drill to be followed by the tap. Many thread sizes have several possible tap drills, because they yield threads of varying thread depth between 50% and 100%.

3. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   A JIC bulkhead adapter, which converts National Pipe Thread ... JIC fittings, defined by the SAE ... 3, 4, 5, 8, and 10 share the same thread size. Some couplings may ...

4. Coupling (piping) - Wikipedia

   en.wikipedia.org/wiki/Coupling_(piping)

   Examples of adapters include one end BSP threaded with the other NPT threaded, and one end threaded with the other a plain socket for brazing. A coupling whose ends use the same connection method but are of different sizes is called a reducing coupling or reducer. An example is a 3/4" NPT to 1/2" NPT coupling.

5. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

6. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Large drill bits can have straight shanks narrower than the drill diameter so that they can be fitted in chucks not able to chuck the full diameter. Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2-inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8-inch (9.5 mm) chuck.

7. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.