Search results
Results from the WOW.Com Content Network
The International Electrotechnical Commission publishes the 60079 series of standards [2] which defines a system for classification of locations, as well as categorizing and testing of equipment designed for use in hazardous locations, known as "Ex equipment". IEC 60079-10-1 covers classification of explosive gas atmospheres, and IEC 60079-10-2 ...
Hazard symbols are universally recognized symbols designed to alert individuals to the presence of hazardous or dangerous materials, locations, or conditions. These include risks associated with electromagnetic fields, electric currents, toxic chemicals, explosive substances, and radioactive materials. Their design and use are often governed by ...
The GHS transport pictograms are the same as those recommended in the UN Recommendations on the Transport of Dangerous Goods, widely implemented in national regulations such as the U.S. Federal Hazardous Materials Transportation Act (49 U.S.C. 5101–5128) and D.O.T. regulations at 49 C.F.R. 100–185.
Intrinsic safety (IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost over ...
Industrial pressure switches may have a calibrated scale and pointer to show the set point of the switch. A pressure switch will have a hysteresis, that is, a differential range around its setpoint, known as the switch's deadband, inside which small changes of pressure do not influence the state of the contacts. Some types allow adjustment of ...
NFPA 704 safety squares on containers of ethyl alcohol and acetone. "NFPA 704: Standard System for the Identification of the Hazards of Materials for Emergency Response" is a standard maintained by the U.S.-based National Fire Protection Association.
Employers can also eliminate hazards by completely removing them—such as clearing trip hazards or disposing of hazardous chemicals, thus eliminating the risks they pose. If eliminating a hazard compromises the ability to produce the product or deliver the service, it's crucial to eliminate as many risks associated with the hazard as possible.
Gases which are compressed, liquefied or dissolved under pressure as detailed below. Some gases have subsidiary risk classes; poisonous or corrosive. 2.1 Flammable Gas: Gases which ignite on contact with an ignition source, such as acetylene, hydrogen, and propane. 2.2 Non-Flammable Gases: Gases which are neither flammable nor poisonous.