Search results
Results from the WOW.Com Content Network
Concentration cells can form in the deposits of corrosion products, leading to localized corrosion. Accelerated low-water corrosion (ALWC) is a particularly aggressive form of MIC that affects steel piles in seawater near the low water tide mark. It is characterized by an orange sludge, which smells of hydrogen sulfide when treated with acid.
EDTMP is normally delivered as its sodium salt, which exhibits good solubility in water. Used in Water treatment as an antiscaling and anti corrosion agent, the corrosion inhibition of EDTMP is 3–5 times better than that of inorganic polyphosphate. It can degrade to Aminomethylphosphonic acid. [2]
The effectiveness of a corrosion inhibitor depends on fluid composition and dynamics. Corrosion inhibitors are common in industry, and also found in over-the-counter products, typically in spray form in combination with a lubricant and sometimes a penetrating oil. They may be added to water to prevent leaching of lead or copper from pipes. [2]
Hydrofluoric acid is a solution of hydrogen fluoride (HF) in water. Solutions of HF are colorless, acidic and highly corrosive . A common concentration is 49% (48-52%) but there are also stronger solutions (e.g. 70%) and pure HF has a boiling point near room temperature.
Nitric acid is an inorganic compound with the formula H N O 3. It is a highly corrosive mineral acid. [6] The compound is colorless, but samples tend to acquire a yellow cast over time due to decomposition into oxides of nitrogen. Most commercially available nitric acid has a concentration of 68% in water.
Water (H 2 O) is a polar inorganic compound that is at room temperature a tasteless and odorless liquid, which is nearly colorless apart from an inherent hint of blue.It is by far the most studied chemical compound [20] and is described as the "universal solvent" [21] and the "solvent of life". [22]
They are highly effective in preventing salt water and hydrogen sulfide (H2S) corrosion. Acrylic polymers: These polymers are used as corrosion inhibitors in the industry due to their good compatibility with oil and drilling fluids. They are effective against corrosion caused by the presence of hydrochloric acid (HCl) in drilling fluids.
If the application of corrosion inhibitors increases the conductivity of the water within the system, the galvanic corrosion potential can be greatly increased. Acidity or alkalinity ( pH ) is also a major consideration with regard to closed loop bimetallic circulating systems.