Search results
Results from the WOW.Com Content Network
A similar device is the vibrator power supply, used to power electronic valve radios from low-voltage batteries. Low voltage DC from the battery is chopped by a trembler circuit and this pulsed square wave used to drive a transformer, providing the 90V or so required by valves. As this application is more frequency sensitive, the vibrators were ...
A modern computer power supply is a switch-mode power supply that converts AC power from the mains supply, to several DC voltages. Switch-mode supplies replaced linear supplies due to cost, weight, efficiency and size improvements. The diverse collection of output voltages also have widely varying current draw requirements.
The primary application of rectifiers is to derive DC power from an AC supply (AC to DC converter). Rectifiers are used inside the power supplies of virtually all electronic equipment. AC/DC power supplies may be broadly divided into linear power supplies and switched-mode power supplies. In such power supplies, the rectifier will be in series ...
When testing power supply circuits, a high-impedance connection (that is, a nearly open-circuit fault such as a burned switch contact or wire joint) in the power path might still allow enough voltage/current through to register on a high-impedance digital voltmeter, but it probably can't actuate the solenoid voltmeter. For use with high ...
Schematic of an inverter using a vibrator as a chopper. In electronics, a chopper circuit is any of numerous types of electronic switching devices and circuits used in power control and signal applications. A chopper is a device that converts fixed DC input to a variable DC output voltage directly.
Typical HT supply circuit schematic. The HT supply was usually obtained from a full wave rectifier circuit similar to the one shown. In those sets that had no mains transformer (the so-called AC/DC design), the HT was obtained directly from the mains supply, either with a simple half wave rectifier or with a voltage doubler circuit.
The power supply is designed to only supply a maximum amount of current that is within the safe operating capability of the shunt regulating device. If the stabilizer must provide more power, the shunt output is only used to provide the standard voltage reference for the electronic device, known as the voltage stabilizer.
IC power-supply pins are voltage and current supply terminals found on integrated circuits (ICs) in electrical engineering, electronic engineering, and integrated circuit design. [a] ICs have at least two pins that connect to the power rails of the circuit in which they are installed. These are known as the power-supply pins. However, the ...