Search results
Results from the WOW.Com Content Network
The erection of a wooden frame in Sabah, Malaysia. The construction frames of a residential subdivision in Rogers, Minnesota in 2023. Framing, in construction, is the fitting together of pieces to give a structure, particularly a building, support and shape. [1] Framing materials are usually wood, engineered wood, or structural steel.
In engineering, span is the distance between two adjacent structural supports (e.g., two piers) of a structural member (e.g., a beam). Span is measured in the horizontal direction either between the faces of the supports (clear span) or between the centers of the bearing surfaces (effective span): [1] A span can be closed by a solid beam or by ...
The Braga Bridge is a continuous truss bridge. It was the fourth longest span of this type when it was completed in 1966. This list of continuous bridge spans ranks the world's continuous truss bridges in two listings: The first is ranked by the length of main span (the longest length of unsupported roadway) and the second by the total length of continuous truss spans.
Building the deck for a railroad bridge requires that a stringer lie directly beneath each rail, and that a stringer support each end of the railroad ties. Ties are usually 6 by 8 inches (150 by 200 mm) in cross-section, and 9 to 12 feet (2.7 to 3.7 m) in length. They are set directly on top of the stringers, about 12 inches (300 mm) apart.
Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);
L is the length of the support (outer) span; b is width; d is thickness; For the 4 pt bend setup, if the loading span is 1/2 of the support span (i.e. L i = 1/2 L in Fig. 4): = If the loading span is neither 1/3 nor 1/2 the support span for the 4 pt bend setup (Fig. 4): Fig. 4 - Beam under 4 point bending
The world's longest suspension bridges are listed according to the length of their main span (i.e., the length of suspended roadway between the bridge's towers). The length of the main span is the most common method of comparing the sizes of suspension bridges, often correlating with the height of the towers and the engineering complexity involved in designing and constructing the bridge. [4]
A swing bridge (or swing span bridge) is a movable bridge that can be rotated horizontally around a vertical axis. It has as its primary structural support a vertical locating pin and support ring, usually at or near to its center of gravity, about which the swing span (turning span) can then pivot horizontally as shown in the animated illustration to the right.