Search results
Results from the WOW.Com Content Network
Yield strength (0.2% offset, ksi) Tensile strength (ksi) Elongation in 2 inches (percent) Hardness (Brinell scale) Comments Copper (ASTM B1, B2, B3, B152, B124, R133) Cu 99.9 Annealed 10 32 45 42 Electrical equipment, roofing, screens Cold-drawn 40 45 15 90 Cold-rolled 40 46 5 100 Gilding metal (ASTM B36) Cu 95.0, Zn 5.0 Cold-rolled 50 56 5 114
The ultimate tensile strength of a material is an intensive property; therefore its value does not depend on the size of the test specimen.However, depending on the material, it may be dependent on other factors, such as the preparation of the specimen, the presence or otherwise of surface defects, and the temperature of the test environment and material.
Bronze is an alloy consisting primarily of copper, commonly with about 12–12.5% tin and often with the addition of other metals (including aluminium, manganese, nickel, or zinc) and sometimes non-metals, such as phosphorus, or metalloids, such as arsenic or silicon.
At 500 °C it is still 0.8% Si, at 400 °C 0.3% Si and at 250 °C only 0.05% Si. At room temperature, silicon is practically insoluble. Aluminum cannot be dissolved in silicon at all, not even at high temperatures. Only in the molten state are both completely soluble. Increases in strength due to solid solution strengthening are negligible. [7]
It is obtained by gradually applying load to a test coupon and measuring the deformation, from which the stress and strain can be determined (see tensile testing). These curves reveal many of the properties of a material, such as the Young's modulus, the yield strength and the ultimate tensile strength.
F Bronze. For brazing tungsten carbide to steels. Primarily used for rock drills or when simultaneous heat treatment is required. 57: 38: 2: 2: Cu 86 Zn 10 Co 4: Cu–Zn 960/1030 [69] – D Bronze. For brazing tungsten carbide to steels. Primarily used for rock drills or when simultaneous heat treatment is required. 86: 10: 4: Cu 85 Sn 8 Ag 7 ...
Ductility: Ability of a material to deform under tensile load (% elongation). It is the property of a material by which it can be drawn into wires under the action of tensile force. A ductile material must have a high degree of plasticity and strength so that large deformations can take place without failure or rupture of the material.
The Brinell hardness number can be correlated with the ultimate tensile strength (UTS), although the relationship is dependent on the material, and therefore determined empirically. The relationship is based on Meyer's index (n) from Meyer's law. If Meyer's index is less than 2.2 then the ratio of UTS to BHN is 0.36.