enow.com Web Search

  1. Ads

    related to: cat 5 to connector cable wire converter

Search results

  1. Results from the WOW.Com Content Network
  2. Category 5 cable - Wikipedia

    en.wikipedia.org/wiki/Category_5_cable

    Cross section of a cat 5e cable. The Category 5e specification improves upon the Category 5 specification by further mitigating crosstalk. [9] The bandwidth (100 MHz) and physical construction are the same between the two, [10] and most Cat 5 cables actually happen to meet Cat 5e specifications even though they are not certified as such. [11]

  3. Ethernet crossover cable - Wikipedia

    en.wikipedia.org/wiki/Ethernet_crossover_cable

    For this, fiber patch cables with duplex connectors are normally configured as crossover as is the on-premises wiring. [ citation needed ] Thus, a simple connection with two patch cables at each end and a section of fixed cable in the middle has three crossovers in total, resulting in a working connection.

  4. Ethernet over twisted pair - Wikipedia

    en.wikipedia.org/wiki/Ethernet_over_twisted_pair

    Since common Category 5 cable has four pairs, it is possible to use the spare pairs (pins 4–5, 7–8) in 10- and 100-Mbit/s configurations for other purposes. The spare pairs may be used for power over Ethernet (PoE), for two plain old telephone service (POTS) lines, or for a second 10BASE-T or 100BASE-TX connection.

  5. Ethernet physical layer - Wikipedia

    en.wikipedia.org/wiki/Ethernet_physical_layer

    Cat-5: Energy-efficient Ethernet variant of 10BASE-T using a reduced amplitude signal over Category 5 cable, completely interoperable with 10BASE-T nodes. 10BASE-T1L: 802.3cg-2019 (146) IEC 63171-1, IEC 63171-6 1000 m Ethernet over a single twisted pair - long reach, for industrial applications 10BASE-T1S: 802.3cg-2019 (147) 25 m

  6. ANSI/TIA-568 - Wikipedia

    en.wikipedia.org/wiki/ANSI/TIA-568

    The standard specifies how to connect eight-conductor 100-ohm balanced twisted-pair cabling, such as Category 5 cable, to 8P8C modular connectors (often referred to as RJ45 connectors). The standard defines two alternative pinouts: T568A and T568B. ANSI/TIA-568 recommends the T568A pinout for horizontal cables.

  7. Power over Ethernet - Wikipedia

    en.wikipedia.org/wiki/Power_over_Ethernet

    In this configuration, an Ethernet connection includes Power over Ethernet (PoE) (gray cable looping below), and a PoE splitter provides a separate data cable (gray, looping above) and power cable (black, also looping above) for a wireless access point. The splitter is the silver and black box in the middle between the wiring junction box (left ...

  1. Ads

    related to: cat 5 to connector cable wire converter