Search results
Results from the WOW.Com Content Network
Stress–strain curve for brittle materials compared to ductile materials. Some common characteristics among the stress–strain curves can be distinguished with various groups of materials and, on this basis, to divide materials into two broad categories; namely, the ductile materials and the brittle materials. [1]: 51
The actual (true) strain in the neck at the point of fracture bears no direct relation to the raw number obtained from the nominal stress-strain curve; the true strain in the neck is often considerably higher. Also, the true stress at the point of fracture is usually higher than the apparent value according to the plot.
Ductility is a material property that can be expressed in a variety of ways. Mathematically, it is commonly expressed as a total quantity of elongation or a total quantity of the change in cross sectional area of a specific rock until macroscopic brittle behavior, such as fracturing, is observed.
For crystalline polymers, the deformation mechanism is best described by a stress-strain curve for a crystalline polymer, such as nylon. The stress-strain behavior exhibits four characteristic regions. The first region is the linear-elastic regime, where the stress-strain behavior is elastic with no plastic deformation.
Stress–strain analysis (or stress analysis) is an engineering discipline that uses many methods to determine the stresses and strains in materials and structures subjected to forces. In continuum mechanics , stress is a physical quantity that expresses the internal forces that neighboring particles of a continuous material exert on each other ...
Brittle materials fracture at low strains and absorb little energy. Conversely, ductile materials fail after significant plastic strain (deformation) and absorb more energy. Note that in this idealized example, the yield and ultimate tensile stresses are the same for both materials; brittle or ductile behavior is not necessarily related to ...
Toughness as defined by the area under the stress–strain curve for one unit volume of the material. In materials science and metallurgy, toughness is the ability of a material to absorb energy and plastically deform without fracturing. [1] Toughness is the strength with which the material opposes rupture.
After dynamic recrystallization, the ductility of the material increases. [1] In a stress–strain curve, the onset of dynamic recrystallization can be recognized by a distinct peak in the flow stress in hot working data, due to the softening effect of recrystallization. However, not all materials display well-defined peaks when tested under ...