Search results
Results from the WOW.Com Content Network
A correction fluid (or correction liquid) is an opaque, usually white fluid applied to paper to mask errors in text. Once dried, it can be handwritten or handdrawn upon. It is typically packaged in small bottles, with lids attached to brushes (or triangular pieces of foam) that dip into the fluid. The brush applies the fluid to the paper.
Ink requirement is defined as the amount of ink needed to print a unit area with a standard Solid Ink Density. For newsprint, the ISO 12647-3 specification is C 0.90, M 0.90, Y 0.90 and K 1.10, Status E, D50, 2o, density minus paper with polarization filter. Ink requirement is measured as g/m2 (grams of ink required to print 1 m2 of paper)
Bottles of ink from Germany Writing ink and a quill. Ink is a gel, sol, or solution that contains at least one colorant, such as a dye or pigment, and is used to color a surface to produce an image, text, or design. Ink is used for drawing or writing with a pen, brush, reed pen, or quill.
Pounce is gently sprinkled all over the writing on the paper. When using a quill or a steel nib, and with inks that are made up to match those typically in use during the 18th and 19th centuries, and provided the pen has been used with the fine strokes typical of handwriting of that period, the handwriting will be sufficiently dry within 10 seconds to allow the paper to be folded without blotting.
In printing, anti-set-off spray powder is used to make an air gap between printed sheets of paper. This enables the ink to dry naturally and therefore avoid the unwanted transfer of ink from one printed sheet to another. The problem can occur with most types of printing.
The paper is then dusted with a powdered polymer that adheres to the ink. The paper is vacuumed or agitated, mechanically or by hand, to remove excess powder, and then heated to near combustion. The wet ink and polymer bond and dry, resulting in a raised print surface similar to the result of an engraving process.
Yellow cyan magenta and black solid ink sticks. The black ink stick is cut in half. Solid ink (also known as hot melt ink [1] [2]) is a type of ink used in printing.Solid ink is a waxy, resin-based polymer that must be melted prior to usage, unlike conventional liquid inks.
In printing, set-off is the term given to the unwanted transfer of ink from one printed sheet to another. The problem can occur with most types of printing, and is avoided by the use of slipsheets between copies (so any ink transfer occurs onto discardable paper) or anti-set-off spray powder .