Search results
Results from the WOW.Com Content Network
Pneumatic valve springs are also found in several Moto GP motorcycle engines, debuting in 2002 with the Aprilia RS Cube. In 2005, Team Roberts was the first to use pneumatic valves full-time in their uncompetitive KTM powered bike. Today, almost all of the MotoGP teams use pneumatic valve technology on their bikes, including Yamaha, Suzuki and ...
In November 2008, Precision Dynamics Corporation acquired TimeMed Labeling Systems, Inc., an American producer of specialty healthcare labels [5] PDC has maintained ISO 9001:2008 certification for many of their products as following safety and other standards for medical devices. [6]
Flow divider valve: a valve providing a plurality of output flows from a single fluid source [2] Flutter (Heimlich) valve: a specific one-way valve used on the end of chest drain tubes to treat a pneumothorax; Foot valve: a check valve on the foot of a suction line to prevent backflow
Rubber Lined Diaphragm Valve. Diaphragm valves (or membrane valves) consists of a valve body with two or more ports, a flexible diaphragm, and a "weir or saddle" or seat upon which the diaphragm closes the valve. The valve body may be constructed from plastic, metal or other materials depending on the intended use.
A rupture disc (burst) Pressure-effect acting at a rupture disc A rupture disc, also known as a pressure safety disc, burst disc, bursting disc, or burst diaphragm, is a non-reclosing pressure relief safety device that, in most uses, protects a pressure vessel, equipment or system from overpressurization or potentially damaging vacuum conditions.
A gas spring consists of a sealed cylinder filled with a charge of high-pressure [5] gas, a piston rod attached to a piston with a sliding seal, and some oil. [1] The piston (or the cylinder wall) contains a number of channels that allow the gas to transfer between the lower chamber (between the piston and the closed end of the cylinder) and the upper chamber (between the piston and the head ...
Valve guides are cylindrical metal bushes, pressed or integrally cast into the cylinder head of most types of reciprocating engines, to support the inlet valve and exhaust valve stems. [1] So that they may make proper contact with its valve seat. Along with a corresponding valve spring, they are one component of an engine’s valve train.
One example of servo valve use is in blow molding where the servo valve controls the wall thickness of extruded plastic making up the bottle or container by use of a deformable die. [10] The mechanical feedback has been replaced by an electric feedback with a position transducer. Integrated electronics close the position loop for the spool.