enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. James Hardie Industries - Wikipedia

   en.wikipedia.org/wiki/James_Hardie_Industries

   James Hardie (27 July 1851 – 20 November 1920) [2] emigrated to Australia in 1888 from Linlithgow, Scotland, and established a business importing oils and animal hides.. Andrew Reid, also from Linlithgow, came to join Hardie in Melbourne, and became a full partner in 1895

3. Negative pulldown - Wikipedia

   en.wikipedia.org/wiki/Negative_pulldown

   The majority of 35 mm film systems, cameras, telecine equipment, optical printers, or projectors, are configured to accommodate the 4-perf system; each frame of 35 mm is 4 perforations long. 4-perf was (and remains) the traditional system, and the majority of projectors are based on 4-perf, because 4 perforations is the amount needed per frame vertically in order to have enough negative space ...

4. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

5. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   A Robertson screw, also known as a square screw [1] or Scrulox, [2] is a type of screw with a square-shaped socket in the screw head and a corresponding square protrusion on the tool. Both the tool and socket have a slight taper .

6. Molly (fastener) - Wikipedia

   en.wikipedia.org/wiki/Molly_(fastener)

   Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...

7. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   ISO general purpose metric screw threads – Part 2: Nominal sizes for 0,2 mm, 0,25 mm and 0,35 mm fine pitch threads; nominal diameter from 1 mm to 50 mm: Active: DIN 13-3: ISO general purpose metric screw threads – Part 3: Nominal sizes for 0,5 mm fine pitch threads; nominal diameter from 3,5 mm to 90 mm: Active: DIN 13-4