Search results
Results from the WOW.Com Content Network
Heater core (arrowed) in the partially disassembled dashboard of a BMW E32. The internal combustion engine in most cars and trucks is cooled by a water and antifreeze mixture that is circulated through the engine and radiator by a water pump to enable the radiator to give off engine heat to the atmosphere. Some of that coolant can be diverted ...
The question of whether or not you should warm your car up before driving it “has two answers depending on what the driver is trying to achieve,” says Shelton.
The light normally appears when the vehicle ignition is turned on, but the engine is not running, as it detects no oil pressure due to the oil pump not operating (the oil pump is powered off the crankshaft, so only operates when the engine is running). It normally turns off a few seconds after engine start as the oil pump starts working and ...
These let you to get your car warm and running ahead of time, but they don't work well in very cold weather, such as when engine coolant gels or freezes. Jumping the battery.
Unlike gas-powered vehicles, running your EV in your garage or out on the street does not produce harmful fumes." Contributing: Coral Murphy Marcos, Dalvin Brown, Ben Tobin, and Minnah Arshad, USA ...
A parked car plugged in to an electrical outlet to power the block heater. Block heaters are frequently used in regions with cold winters such as the northern United States, Canada, Russia and Scandinavia. In some countries where block heaters are commonly used, carparks are sometimes fitted with electrical outlets for powering the block heaters.
A crankcase heater is an electrical component in a compressor in an air-conditioning system, heat pump system, or chiller system. The crankcase heater is normally on all the time, even when the unit is not running, though temperature sensors and set points may turn it off when not needed.
A thermotime switch, or TTS, is a sensor used to control the cold start enrichment process in some older fuel injection systems. An extra injector is placed in the inlet manifold designed to feed all of the cylinders, and whilst the other injectors have flow rates controlled by pulse duration, the cold start injector stays on during the initial cold starting procedure.