Search results
Results from the WOW.Com Content Network
The center console (American English) or centre console in an automobile consists of the control-bearing surfaces in the center of the front of the vehicle interior. The term is applied to the area beginning in the dashboard and continuing beneath it, and often merging with the transmission tunnel which runs between the front driver's and ...
A trolling motor is a self-contained marine propulsion unit that includes an electric motor, propeller and control system, and is affixed to an angler's boat, either at the bow or stern. A gasoline-powered outboard used in trolling , if it is not the vessel's primary source of propulsion, may also be referred to as a trolling motor.
An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft.
Headquarters A Mercury 50 HP outboard motor circa 1980 Six cylinder two-stroke engine in 1984. Mercury Marine is a marine engine division of Brunswick Corporation headquartered in Fond du Lac, Wisconsin.
Vertical transom and stern of a modern cargo ship. In some boats and ships, a transom is the aft transverse surface of the hull that forms the stern of a vessel. Historically, they are a development from the canoe stern (or "double-ender") wherein which both bow and stern are pointed. Transoms add both strength and width to the stern.
This is an accepted version of this page This is the latest accepted revision, reviewed on 18 January 2025. Back or aft-most part of a ship or boat For other uses, see Stern (disambiguation). Detailed schematic of an elliptical or "fantail" stern The flat transom stern of the cargo ship Sichem Princess Marie-Chantal The stern is the back or aft -most part of a ship or boat, technically defined ...
A clinker-built Viking longship, whose overlapping planks constitute "strakes". Garboard strakes and related near-keel members Diagram of typical modern metal-hulled ship’s exterior plating, with a single strake highlighted in red
In adjustable shelving systems, the bracket may be in two parts, with the load-bearing horizontal support fitting into a wall-mounted slotted vertical metal strip. Brackets also are an element in the systems used to mount modern facade cladding systems onto the outside of contemporary buildings, as well as interior panels.