Search results
Results from the WOW.Com Content Network
The AN/URM-25 was part of a series of vacuum tube-based signal generators built for the U.S. military in the early Cold War-era.. Today they are collected and used by vintage amateur radio and antique radio enthusiasts who say they provide reasonably high accuracy and stability for a low cost, with build quality reflecting tough military construction requirements and standards.
The combined test signal can be injected directly in to the receiver if the antenna is removable. A second directional coupler, connected in the conventional configuration, can be used to provide a feed of the input to a spectrum analyser. This allows confirmation that the input signal is free of intermodulation products.
A signal strength and readability report is a standardized format for reporting the strength of the radio signal and the readability (quality) of the radiotelephone (voice) or radiotelegraph (Morse code) signal transmitted by another station as received at the reporting station's location and by their radio station equipment. These report ...
The S stands for "Strength". Strength is an assessment of how powerful the received signal is at the receiving location. Although an accurate signal strength meter can determine a quantitative value for signal strength, in practice this portion of the RST code is a qualitative assessment, often made based on the S meter of the radio receiver at the location of signal reception.
Several countries in ITU Region 1 have access to frequencies in the 70 MHz region, called the 4-meter band. The band shares many propagation characteristics with 6 meters. The preferred location for beacons is 70.000–70.090 MHz; [5] however, in countries where this segment is not allocated to Amateur Radio, beacons may operate elsewhere in ...
A wireless site survey, sometimes called an RF (Radio Frequency) site survey or wireless survey, is the process of planning and designing a wireless network, to provide a wireless solution that will deliver the required wireless coverage, data rates, network capacity, roaming capability and quality of service (QoS). [1]
An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT). Incorporating a switch into a switch matrix system enables you to route signals ...
Cable length limits the controller-device distance to two meters per device or 20 meters total, whichever is less. This imposes transmission problems on systems spread out in a room or on systems that require remote measurements. Primary addresses limit the system to 30 devices with primary addresses. Modern instruments rarely use secondary ...