enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Laboratory drying rack - Wikipedia

   en.wikipedia.org/wiki/Laboratory_drying_rack

   The examples of stainless steel laboratory drying rack are flask holders, soap dispensers, paper towel dispensers, glove box holders, drain shelves. [1] Stainless steel pegboard installation is very easy and quick to set up with basic hand equipment's, and it does not damage the wall as mounting brackets and hardware are being used.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

4. Bottle cage - Wikipedia

   en.wikipedia.org/wiki/Bottle_cage

   Many small tire pumps come with a mounting bracket intended to be mounted alongside a bottle cage. The Trek Soho 3.0 comes with a stainless steel coffee mug designed to fit in the bottle cage mounted on the front side of the seat tube.

5. Spacers and standoffs - Wikipedia

   en.wikipedia.org/wiki/Spacers_and_standoffs

   They are usually round or hex (for wrench tightening), often made of stainless steel, aluminum, brass, or nylon, and come in male-female or female-female forms. In electronics they are frequently used to raise a printed-circuit board above a surface. Insulating standoffs keep two parts from touching each other, thereby preventing electrical shorts.

6. Strut channel - Wikipedia

   en.wikipedia.org/wiki/Strut_channel

   Strut is normally made of sheet steel, with a zinc coating (), paint, epoxy, powder coat, or other finish.. Strut channel is also manufactured from stainless steel for use where rusting might become a problem (e.g., outdoors, facilities with corrosive materials), from aluminium alloy when weight is an issue or from fiberglass for very corrosive environments.

7. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   Screw clamps consist of a band, often galvanized or stainless steel, into which a screw thread pattern has been cut or pressed. One end of the band contains a captive screw. The clamp is put around the hose or tube to be connected, with the loose end being fed into a narrow space between the band and the captive screw.