Search results
Results from the WOW.Com Content Network
For example, the ionic strength of the solution can have an effect on the activity coefficients of the analytes. [3] [4] The most common approach for accounting for matrix effects is to build a calibration curve using standard samples with known analyte concentration and which try to approximate the matrix of the sample as much as possible. [2]
Chemical tests use reagents to indicate the presence of a specific chemical in an unknown solution. The reagents cause a unique reaction to occur based on the chemical it reacts with, allowing one to know what chemical is in the solution. An example is Heller's test where a test tube
In analytical chemistry, a standard solution (titrant or titrator) is a solution containing an accurately known concentration.Standard solutions are generally prepared by dissolving a solute of known mass into a solvent to a precise volume, or by diluting a solution of known concentration with more solvent. [1]
Gravimetric analysis describes a set of methods used in analytical chemistry for the quantitative determination of an analyte (the ion being analyzed) based on its mass. The principle of this type of analysis is that once an ion's mass has been determined as a unique compound, that known measurement can then be used to determine the same analyte's mass in a mixture, as long as the relative ...
Once the presence of certain substances in a sample is known, the study of their absolute or relative abundance could help in determining specific properties. Knowing the composition of a sample is very important, and several ways have been developed to make it possible, like gravimetric [3] and volumetric analysis. Gravimetric analysis yields ...
In LC, the concerns involving sample preparation can be minimal. In LC, both the stationary and mobile phase can affect the separation, whereas in GC only the stationary phase should be influential. This allows for the sample preparation to be minimal if one is willing to adjust the stationary phase or mobile phase before running the sample.
Quality control begins with sample collection and ends with the reporting of data. [4] AQC is achieved through laboratory control of analytical performance. Initial control of the complete system can be achieved through specification of laboratory services, instrumentation, glassware, reagents, solvents, and gases.
When working with limiting amount of sample, an analyst might need to make a single addition, but it is generally considered a best practice to make at least two additions whenever possible. [5] Note that this is not limited to liquid samples. In atomic absorption spectroscopy, for example, standard additions are often used with solid as the ...