Search results
Results from the WOW.Com Content Network
An oedometer test is a kind of geotechnical investigation performed in geotechnical engineering that measures a soil's consolidation properties. Oedometer tests are performed by applying different loads to a soil sample and measuring the deformation response.
The rate of axial deformation is kept constant, i.e., strain is controlled. The test allows the sample and the pore pressures to fully consolidate (i.e., adjust) to the surrounding stresses. The test may take a long time to allow the sample to adjust, in particular low permeability samples need a long time to drain and adjust strain to stress ...
The design stage includes a survey phase(1), a diagnosis phase(2) and a therapy phase(3). The construction stage consists of an operational phase(4), a monitoring phase and a final design adjustment phase(5). [2] In survey phase(1): to determine the geomechanical knowledge and characteristics of the medium where the tunnel is located in.
This is a soil test-based definition, usually performed via cyclic triaxial, cyclic direct simple shear, or cyclic torsional shear type apparatus. These tests are performed to determine a soil's resistance to liquefaction by observing the number of cycles of loading at a particular shear stress amplitude required to induce 'fails'.
A sieve analysis (or gradation test) is a practice or procedure used in geology, civil engineering, [1] and chemical engineering [2] to assess the particle size distribution (also called gradation) of a granular material by allowing the material to pass through a series of sieves of progressively smaller mesh size and weighing the amount of material that is stopped by each sieve as a fraction ...
In the initial stage of deformation, the volumetric strain decreases as the shear strain increases. But as the stress approaches its peak value, the volumetric strain starts to increase. After some more shear, the soil sample has a larger volume than when the test was started. The amount of dilation depends strongly on the initial density of ...
It's the point at which the soil cannot sustain any additional load without undergoing continuous deformation, in a manner similar to the behaviour of fluids. Certain properties of the soil, like porosity, shear strength, and volume, reach characteristic values. These properties are intrinsic to the type of soil and its initial conditions. [1]
A direct shear test is a laboratory or field test used by geotechnical engineers to measure the shear strength properties of soil [1] [2] or rock [2] material, or of discontinuities in soil or rock masses. [2] [3] The U.S. and U.K. standards defining how the test should be performed are ASTM D 3080, AASHTO T236 and BS 1377-7:1990