Search results
Results from the WOW.Com Content Network
The 1969 Universal offered a "462" performance package. It was a limited-production model that featured the V6 engine, front bucket seats and a rear bench, roll bar, heavy-duty frame and springs, a locking differential, oil-pan skid plate, rear swing-out tire carrier, full wheel covers, ammeter, and oil pressure gauges; padded visors were optional.
Like all other GM divisions, Olds continued building its own V8 engine family for decades, adopting the corporate Chevrolet 350 small-block and Cadillac Northstar engine only in the 1990s. All Oldsmobile V8s were assembled at plants in Lansing, Michigan while the engine block and cylinder heads were cast at Saginaw Metal Casting Operations .
The Willys F4-134 Hurricane was an inline-4 F-head piston engine that powered the M38A1 military Jeep in 1952, followed by the famous Jeep CJ in the CJ-3B, CJ-5, and CJ-6 models. It was also used in the Willys 473 and 475 pickups, wagons, and sedan deliveries.
1948 Oldsmobile Straight-8 engine Oldsmobile inline 8 engine at the R. E. Olds Transportation Museum. Oldsmobile produced a straight-8 engine in the 1930s and 1940s. This was the company's top engine choice from 1932 until the 1949 introduction of the overhead valve Rocket V8, and was briefly exclusive to the Oldsmobile L-Series.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission).
Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...
The 221.4 cu in (3.628 L) was used by the Oldsmobile F-Series for one year in 1933 and then reverted to using the 213. It had a 3 3/8" bore and 4 1/8" stroke. This 1933 engine was the first Olds to use removable "shell" bearings in lieu of the earlier poured in place babbit bearings.
The Oldsmobile Diesel engine is a series of V6 and V8 diesel engines produced by General Motors from 1978 to 1985. Their design was based on the Olds 350 gasoline engine architecture. A 350 cu in (5.7 L) V8 was introduced in 1978, followed by a 261 cu in (4.3 L) V8 only for the 1979 model year.