Search results
Results from the WOW.Com Content Network
Autonegotiation is a signaling mechanism and procedure used by Ethernet over twisted pair by which two connected devices choose common transmission parameters, such as speed, duplex mode, and flow control. In this process, the connected devices first share their capabilities regarding these parameters and then choose the highest-performance ...
This would require the wireless access point to be connected to the rest of the network with 2 Ethernet cables and require both the wireless access point and network hardware to support and be configured for link aggregation. Wireless access points that support 2.5GBASE-T or 5GBASE-T eliminate this complexity.
Average speeds are more commonly used but can give a wrong impression of the actual user experience since fast connections can bias the average results. Median results represent the point where half the population has faster and the other half of the population has slower data transfer rates.
Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only ...
The prior Ethernet speed was 10 Mbit/s. Of the Fast Ethernet physical layers, 100BASE-TX is by far the most common. Fast Ethernet was introduced in 1995 as the IEEE 802.3u standard [1] and remained the fastest version of Ethernet for three years before the introduction of Gigabit Ethernet. [2]
The propagation delay of a physical link can be calculated by dividing the distance (the length of the medium) in meter by its propagation speed in m/s. Propagation time = Distance / propagation speed. Example: Ethernet communication over a UTP copper cable with maximum distance of 100 meter between computer and switching node results in:
50 Ω coaxial cable connects machines together, each machine using a T-connector to connect to its NIC. Requires terminators at each end. For many years during the mid to late 1980, this was the dominant Ethernet standard. Also called Thin Ethernet, Thinnet or Cheapernet. 10 Mbit/s over RG-58 coaxial cabling, bus topology with collision ...
The algorithms speed up the data transfer until packets start to drop, then slow down the transmission rate. Ideally, they keep adjusting the transmission rate until it reaches an equilibrium speed of the link. So that the algorithms can select a suitable transfer speed, the feedback about packet drops must occur in a timely manner.