enow.com Web Search

  1. Ads

    related to: 8 led spots 12v dimmable switch for lights

Search results

  1. Results from the WOW.Com Content Network
  2. LED strip light - Wikipedia

    en.wikipedia.org/wiki/LED_strip_light

    An LED strip, tape, or ribbon light is a flexible circuit board populated by surface-mount light-emitting diodes (SMD LEDs) and other components that usually comes with an adhesive backing. Traditionally, strip lights had been used solely in accent lighting, backlighting, task lighting, and decorative lighting applications, such as cove lighting .

  3. LED lamp - Wikipedia

    en.wikipedia.org/wiki/LED_lamp

    A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

  4. Light switch - Wikipedia

    en.wikipedia.org/wiki/Light_switch

    Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]

  5. Dimmer - Wikipedia

    en.wikipedia.org/wiki/Dimmer

    A thyristor dimmer rack An electrical schematic for a typical SCR-based light dimmer Solid-state , or semiconductor , dimmers were introduced to solve some of these problems. Semiconductor dimmers switch on at an adjustable time (phase angle) after the start of each alternating-current half-cycle, thereby altering the voltage waveform applied ...

  6. Multifaceted reflector - Wikipedia

    en.wikipedia.org/wiki/Multifaceted_reflector

    These lamps use a bi-pin connector for power: 12-volt MR11 bulbs usually use a GU4 base, and 12-volt MR16 bulbs usually use a GU5.3 base. The common 12-volt MR16 lamps, therefore, require a ferromagnetic or electronic transformer —sometimes misnamed as a ballast —to convert the 120- or 230-volt mains voltage to the extra-low voltage ...

  7. Light-emitting diode physics - Wikipedia

    en.wikipedia.org/wiki/Light-emitting_diode_physics

    A LED is a long-lived light source, but certain mechanisms can cause slow loss of efficiency of the device or sudden failure. The wavelength of the light emitted is a function of the band gap of the semiconductor material used; materials such as gallium arsenide , and others , with various trace doping elements , are used to produce different ...

  1. Ads

    related to: 8 led spots 12v dimmable switch for lights