Ad
related to: roof ridge beam framing detail autocad dwg 2d top view
Search results
Results from the WOW.Com Content Network
The ridge board of their roof is not carried by king posts based on tie beams, but the ridge posts are based on the ground work. The German term for this construction is Firstständerhaus. The free-standing posts in the interior of the house and the posts in the gable or lateral walls were originally called Firstsäule ("ridge columns"). On a ...
Timber roof truss example. The top members of a truss are known generically as the top chord, bottom members as the bottom chord, and the interior members as webs. In historic carpentry the top chords are often called rafters, and the bottom chord is often referred to as a tie beam. There are two main types of timber roof trusses: closed, in ...
DXF was introduced in December 1982 as part of AutoCAD 1.0, and was intended to provide an exact representation of the data in the AutoCAD native file format, DWG (Drawing). For many years, Autodesk did not publish specifications, making correct creation of DXF files difficult. Autodesk now publishes the incomplete [3] DXF specifications online.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
The completed frame of a modern timber-frame house Ridge-post framing (left) and story framing (right, with jetties) Historically, the timbers would have been hewn square using a felling axe and then surface-finished with a broadaxe. If required, smaller timbers were ripsawn from the hewn baulks using pitsaws or frame saws.
Section view through a house roof drawing showing names for parts of the structure. [clarification needed] (UK and Australia). Ctrs. means centers, a typical line to which carpenters layout framing. Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1]
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
Ad
related to: roof ridge beam framing detail autocad dwg 2d top view