Search results
Results from the WOW.Com Content Network
On average, in a household of average size (2.65 persons) 12.4 showers are taken each week. For comparison, a navy shower lasts only 2 minutes and can use less than 3 gallons (11.4 liters) of water. The most water-frugal approach is used by the crew of the International Space Station (ISS) who use less than 1 gallon (4 liters) to bathe. [13]
The gallon is a unit of volume in British imperial units and United States customary units.. The imperial gallon (imp gal) is defined as 4.546 09 litres, and is or was used in the United Kingdom and its former colonies, including Ireland, Canada, Australia, New Zealand, India, South Africa, Malaysia and some Caribbean countries, while the US gallon (US gal) is defined as 231 cubic inches (3. ...
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
Wine was measured with units based on the wine gallon of 231 cubic inches (3.785 L), beer was measured with units based on an ale gallon of 282 cubic inches (4.621 L) and grain was measured with the Winchester measure with a gallon of approximately 268.8 cubic inches (one eighth of a Winchester bushel or 4.405 L). In 1824, these units were ...
Typically, it is written in the form x/y, where x is the percentage of weight in the front, and y is the percentage in the back. In a vehicle which relies on gravity in some way, weight distribution directly affects a variety of vehicle characteristics, including handling , acceleration , traction , and component life.
Most water in Earth's atmosphere and crust comes from saline seawater, while fresh water accounts for nearly 1% of the total. The vast bulk of the water on Earth is saline or salt water, with an average salinity of 35‰ (or 3.5%, roughly equivalent to 34 grams of salts in 1 kg of seawater), though this varies slightly according to the amount of runoff received from surrounding land.
To obtain 4 liters using 3-liter and 5-liter jugs, we want to reach the point (4, 0). From the point (4, 0), there are only two reversible actions: filling the empty 3-liter jug to full from the tap (4,3), or transferring 1 liter of water from the 5-liter jug to the 3-liter jug (1,3). Therefore, there are only two solutions to the problem:
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).