Search results
Results from the WOW.Com Content Network
UPS in the gas phase, IPREM, Pau, France, Dr. JM Sotiropoulos, CNRS. The ultraviolet photoelectron spectroscopy (UPS) was pioneered by Feodor I. Vilesov, a physicist at St. Petersburg (Leningrad) State University in Russia (USSR) in 1961 to study the photoelectron spectra of free molecules in the gas phase.
A UPS designed for powering DC equipment is very similar to an online UPS, except that it does not need an output inverter. Also, if the UPS's battery voltage is matched with the voltage the device needs, the device's power supply will not be needed either. Since one or more power conversion steps are eliminated, this increases efficiency and ...
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
A schematic, or schematic diagram, is a designed representation of the elements of a system using abstract, graphic symbols rather than realistic pictures. A schematic usually omits all details that are not relevant to the key information the schematic is intended to convey, and may include oversimplified elements in order to make this essential meaning easier to grasp, as well as additional ...
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.
Most forms of uninterruptible power supply (UPS) can be either powered by battery or flywheel energy. These are ready for immediate use at the instant that the mains electricity fails, but the relatively small and finite amount of stored energy they contain makes them suitable for short periods of use, typically in the order of a few dozen minutes to a couple of hours depending on the actual load.
Schematic of an inverter using a vibrator as a chopper. In electronics, a chopper circuit is any of numerous types of electronic switching devices and circuits used in power control and signal applications. A chopper is a device that converts fixed DC input to a variable DC output voltage directly.
The following table is split into two groups based on whether it has a graphical visual interface or not. The latter requires a separate program to provide that feature, such as Qucs-S, [1] Oregano, [2] or a schematic design application that supports external simulators, such as KiCad or gEDA.