Search results
Results from the WOW.Com Content Network
If water is used, the time should be 26 +/- 0.5 seconds. [2] If the time is less than this the tube is probably enlarged by erosion, if more it may be blocked or damaged, and the funnel should be replaced. In some companies, and Europe in particular, the volume collected is a litre, for which the water funnel time should be 28 seconds.
Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.
The values for the octanol-water system in the following table are from the Dortmund Data Bank. [ 15 ] [ better source needed ] They are sorted by the partition coefficient, smallest to largest (acetamide being hydrophilic, and 2,2',4,4',5-pentachlorobiphenyl lipophilic), and are presented with the temperature at which they were measured (which ...
The Mapei Group has been publishing a two-monthly magazine in Italian and English since 1991. Adriana Spazzoli was the editor-in-chief of the magazine called Realtà Mapei for 28 years until 2019. 160,000 copies of the magazine are distributed all over Italy and 22,000 copies of Realtà Mapei International are published worldwide.
The following chart shows the solubility of various ionic compounds in water at 1 atm pressure and room temperature (approx. 25 °C, 298.15 K). "Soluble" means the ionic compound doesn't precipitate, while "slightly soluble" and "insoluble" mean that a solid will precipitate; "slightly soluble" compounds like calcium sulfate may require heat to precipitate.
The ultimate strength of concrete is influenced by the water-cementitious ratio (w/cm), the design constituents, and the mixing, placement and curing methods employed.All things being equal, concrete with a lower water-cement (cementitious) ratio makes a stronger concrete than that with a higher ratio. [2]
The water-cement ratio of the fresh concrete mix is one of the main, if not the most important, factors determining the quality and properties of hardened concrete, as it directly affects the concrete porosity, and a good concrete is always a concrete as compact and as dense as possible.
Different grout may be needed for fine grained and coarse grained soils in the grouted area. The greatest use of pressure grouting is to improve geomaterials (soil and rock). The purpose of grouting can be either to strengthen a formation or to reduce water flow through it. It is also used to correct faults in concrete and masonry structures.