Search results
Results from the WOW.Com Content Network
Charge carrier density, also known as carrier concentration, denotes the number of charge carriers per volume. In SI units, it is measured in m −3. As with any density, in principle it can depend on position. However, usually carrier concentration is given as a single number, and represents the average carrier density over the whole material.
In electrical engineering, electrical length is a dimensionless parameter equal to the physical length of an electrical conductor such as a cable or wire, divided by the wavelength of alternating current at a given frequency traveling through the conductor. [ 1 ][ 2 ][ 3 ] In other words, it is the length of the conductor measured in wavelengths.
The SI unit of electrical resistivity is the ohm - metre (Ω⋅m). [1][2][3] For example, if a 1 m3 solid cube of material has sheet contacts on two opposite faces, and the resistance between these contacts is 1 Ω, then the resistivity of the material is 1 Ω⋅m. Electrical conductivity (or specific conductance) is the reciprocal of ...
Electron mobility. In solid-state physics, the electron mobility characterises how quickly an electron can move through a metal or semiconductor when pushed or pulled by an electric field. There is an analogous quantity for holes, called hole mobility. The term carrier mobility refers in general to both electron and hole mobility.
The specific strength is a material's (or muscle's) strength (force per unit area at failure) divided by its density. It is also known as the strength-to-weight ratio or strength/weight ratio or strength-to-mass ratio. In fiber or textile applications, tenacity is the usual measure of specific strength. The SI unit for specific strength is Pa ...
Copper has one free electron per atom, so n is equal to 8.5 × 10 28 electrons per cubic metre. Assume a current I = 1 ampere, and a wire of 2 mm diameter (radius = 0.001 m). This wire has a cross sectional area A of π × (0.001 m) 2 = 3.14 × 10 −6 m 2 = 3.14 mm 2. The elementary charge of an electron is e = −1.6 × 10 −19 C.
120 fathoms. 720 ft. Metric (SI) units. 219.5 m. A cable length or length of cable is a nautical unit of measure equal to one tenth of a nautical mile or approximately 100 fathoms. Owing to anachronisms and varying techniques of measurement, a cable length can be anywhere from 169 to 220 metres (185 to 241 yd), depending on the standard used.
P / V. Power density, defined as the amount of power (the time rate of energy transfer) per unit volume, is a critical parameter used across a spectrum of scientific and engineering disciplines. This metric, typically denoted in watts per cubic meter (W/m 3), serves as a fundamental measure for evaluating the efficacy and capability of various ...