enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Loft conversions in the United Kingdom - Wikipedia

   en.wikipedia.org/wiki/Loft_conversions_in_the...

   Due to the slope of the roof and the required access headroom, the feasibility of a loft conversion is dependent upon a minimum height of approximately 2.2 m (7 ft 6 in) measured from the joist to the apex. Providing that this requirement is met, most properties will likely possess the potential to have the loft space converted.

3. Roof pitch - Wikipedia

   en.wikipedia.org/wiki/Roof_pitch

   Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);

4. Truss - Wikipedia

   en.wikipedia.org/wiki/Truss

   Roof truss. A planar truss lies in a single plane. [14] Planar trusses are typically used in parallel to form roofs and bridges. [16] The depth of a truss, or the height between the upper and lower chords, is what makes it an efficient structural form.

5. Timber roof truss - Wikipedia

   en.wikipedia.org/wiki/Timber_roof_truss

   Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.

6. Hammerbeam roof - Wikipedia

   en.wikipedia.org/wiki/Hammerbeam_roof

   A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.

7. Domestic roof construction - Wikipedia

   en.wikipedia.org/wiki/Domestic_roof_construction

   A truss roof with tongue and groove sheathing. The gap in the sheathing at the ridge is the space designed to allow natural ventilation. Pre-manufactured roof trusses come in a wide variety of styles. They are designed by the manufacturer for each specific building. Timber trusses also are built in a variety of styles using wood or metal joints.