Search results
Results from the WOW.Com Content Network
The flicker of a CRT monitor can cause various symptoms in those sensitive to it such as eye strain, headaches [9] in migraine sufferers, and seizures in epileptics. [10]As the flicker is most clearly seen at the edge of our vision there is no obvious risk in using a CRT, but prolonged use can cause a sort of retinal shock where the flickering is seen even when looking away from the monitor.
Flicker-free is a term given to video displays, primarily cathode ray tubes, operating at a high refresh rate to reduce or eliminate the perception of screen flicker.For televisions, this involves operating at a 100 Hz or 120 Hz hertz field rate to eliminate flicker, compared to standard televisions that operate at 50 Hz (PAL, SÉCAM systems) or 60 Hz (), most simply done by displaying each ...
Flicker: Perceptible on lower refresh rates (60 fps and below) [22] Depends; in 2013 most LCDs used PWM to dim the backlight [23] However, since then many flicker free LCD computer monitors were introduced. [24] Does not normally occur due to a high refresh rate higher than FPS [25] Does not normally occur at 100% brightness level.
Detail of a TFT display showing whole screen persistence artifacts TFT display showing persistence artifacts Image persistence on a BenQ GW2765HT IPS LCD monitor. Image persistence, or image retention, is a phenomenon in LCD and plasma displays where unwanted visual information is shown which corresponds to a previous state of the display.
LG introduced a similar 'Motion 240' option on their 24GM77 gaming monitor; ULMB is a technique provided alongside Nvidia's G-Sync technology, and linked to the G-Sync monitor module. It is an alternative option to using G-Sync (and cannot be used at the same time), offering the user instead an "Ultra Low Motion Blur" mode.
However, this does not apply to LCD monitors. The closest equivalent to a refresh rate on an LCD monitor is its frame rate, which is often locked at 60 fps. But this is rarely a problem, because the only part of an LCD monitor that could produce CRT-like flicker—its backlight—typically operates at around a minimum of 200 Hz.
Nevertheless, this is almost identical to the use of casual stopwatches on two monitors using a "clone view" monitor setup as it does not care about the missing synchronisation between the composite video signal and the display of the laptop's screen or the display lag of that screen or the detail that the vertical screen refresh of the two ...
This ability (plus built-in genlocking) resulted in the Amiga dominating the video production field until the mid-1990s, but the interlaced display mode caused flicker problems for more traditional PC applications where single-pixel detail is required, with "flicker-fixer" scan-doubler peripherals plus high-frequency RGB monitors (or Commodore ...