Search results
Results from the WOW.Com Content Network
A DC injection brake system can be used as an alternative or addition to a friction brake system. DC injection brakes only require a small module located with the other motor switchgear and/or drivers, mounted in a remote and convenient location, whereas a friction brake must be mounted somewhere on the rotating system. Friction brakes ...
For the tests the vehicle brake for which the replacement linings are designed is installed in an inertia dynamometer instrumented for continuous recording of rotative speed, brake torque, brake line pressure, number of rotations after brake application, braking time, and brake rotor temperature.
The purpose is to reduce failures in hydraulic braking systems of motor vehicles which may occur because of the manufacture or use of improper or contaminated fluid. The standard applies to all fluid use of passenger cars, multipurpose passenger vehicles, trucks, buses, trailers and motorcycles equipped with a hydraulic brake system. [1]
In the not-too-distant future, automatic emergency braking will have to come standard on all new passenger vehicles in the United States, a requirement that the government says will save hundreds ...
Maximum brake torque (MBT) is the use of optimal ignition timing to take advantage of an internal combustion engine's maximum power and efficiency. There is always an optimal spark timing for all operating conditions of an engine. MBT is ideal at wide-open throttle (WOT), but not desirable when the engine is at idle.
Braking distance refers to the distance a vehicle will travel from the point when its brakes are fully applied to when it comes to a complete stop. It is primarily affected by the original speed of the vehicle and the coefficient of friction between the tires and the road surface, [Note 1] and negligibly by the tires' rolling resistance and vehicle's air drag.
Speed has dropped out of the equation, and the only variables are the torque and displacement volume. Since the range of maximum brake mean effective pressures for good engine designs is well established, we now have a displacement-independent measure of the torque-producing capacity of an engine design – a specific torque of sorts.
The driver requests the torque or engine speed requirements via accelerator pedal potentiometer thereby sending a signal to the engine ECU which then, depending on its mapping and data collected from various sensors, calculates in real time the quantity of injected fuel required, thus altering the fuel rack to the required position.