Search results
Results from the WOW.Com Content Network
The SNOX process is a very energy-efficient way to convert the NOx in the flue gas into nitrogen and the SOx into concentrated sulfuric acid of commercial quality without using any absorbents and without producing waste products or waste water.
Ammonia flow is in general controlled based on NOx measurements taken from the gas stream or preexisting performance curves from an engine manufacturer (in the case of gas turbines and reciprocating engines). Typically, all future operating conditions must be known beforehand to properly design and tune an SCR system.
The term NO x represents several forms of nitrogen oxides such as NO (nitric oxide), NO 2 (nitrogen dioxide) and N 2 O (nitrous oxide, also known as laughing gas).In a gasoline engine, NO is the most common form of NO x at around 93%, while NO 2 is around 5% and the rest is N 2 O.
CEMS typically consist of analyzers to measure gas concentrations within the stream, equipment to direct a sample of that gas stream to the analyzers if they are remote, equipment to condition the sample gas by removing water and other components that could interfere with the reading, pneumatic plumbing with valves that can be controlled by a ...
In atmospheric chemistry, NO x is shorthand for nitric oxide (NO) and nitrogen dioxide (NO 2), the nitrogen oxides that are most relevant for air pollution. [1] [2] These gases contribute to the formation of smog and acid rain, as well as affecting tropospheric ozone.
A nondispersive infrared sensor (or NDIR sensor) is a simple spectroscopic sensor often used as a gas detector.It is non-dispersive in the fact that no dispersive element (e.g a prism or diffraction grating as is often present in other spectrometers) is used to separate out (like a monochromator) the broadband light into a narrow spectrum suitable for gas sensing.
Selective non-catalytic reduction (SNCR) is a method to lessen nitrogen oxide emissions in conventional power plants that burn biomass, waste and coal.The process involves injecting either ammonia or urea into the firebox of the boiler at a location where the flue gas is between 1,400 and 2,000 °F (760 and 1,090 °C) to react with the nitrogen oxides formed in the combustion process.
The emissions specifically include SOx, NOx, ODSs and VOCs [2] and the regulations came into effect in May 2005. [ 3 ] [ 4 ] Annex VI contains provisions for two sets of emission and fuel quality requirements regarding SOx and PM, or NOx, a global requirement and more stringent controls in special emission control areas (ECA). [ 5 ]