Search results
Results from the WOW.Com Content Network
Typical dimensions are on the order of approximately 100–140 mm (4–5 1 ⁄ 2 in.) in length and 3–5 mm (1 ⁄ 8 – 3 ⁄ 16 in.) in width. Best used for fine, delicate work on small pieces or mechanisms (such as escapements ), escapement files are commonly used by clock and watchmakers , as well as in crafting jewelry.
[8] 1-simple guillotine cutting is a restricted variant of guillotine-cutting in which each cut separates a single rectangle. A 2-simple guillotine cutting is a 1-simple pattern such that each part is itself a 1-simple pattern. p-simple cutting patterns can be defined recursively. [9]
The metric drawing sizes correspond to international paper sizes. These developed further refinements in the second half of the twentieth century, when photocopying became cheap. Engineering drawings could be readily doubled (or halved) in size and put on the next larger (or, respectively, smaller) size of paper with no waste of space.
bolt circle: BCD or B.C.D. bolt circle diameter: BHC bolt hole circle Same definition as the bolt circle diameter BHCS: button head cap screw: Like an SHCS but with a button head. BHN: Brinell hardness number: BoM or BOM: bill of materials: Also called a list of materials (LM or L/M). Overlaps a lot in concept with a parts list (PL or P/L ...
The most efficient way to pack different-sized circles together is not obvious. In geometry, circle packing is the study of the arrangement of circles (of equal or varying sizes) on a given surface such that no overlapping occurs and so that no circle can be enlarged without creating an overlap.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
A circle of radius 23 drawn by the Bresenham algorithm. In computer graphics, the midpoint circle algorithm is an algorithm used to determine the points needed for rasterizing a circle. It is a generalization of Bresenham's line algorithm. The algorithm can be further generalized to conic sections. [1] [2] [3]
In machining, the rake angle is a parameter used in various cutting processes, describing the angle of the cutting face relative to the workpiece. There are three types of rake angles: positive, zero or neutral, and negative. Positive rake: A tool has a positive rake when the face of the cutting tool slopes away from the cutting edge at inner side.