enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Belling-Lee connector - Wikipedia

   en.wikipedia.org/wiki/Belling-Lee_connector

   Female Belling-Lee connector on a television set. The Belling-Lee connector (also type 9,52, but largely only in the context of its specification, IEC 61169, Part 2: Radio-frequency coaxial connector of type 9,52) [1] is commonly used in Europe, parts of Southeast Asia, and Australia, to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal ...

3. Television antenna - Wikipedia

   en.wikipedia.org/wiki/Television_antenna

   The standard today is 75 ohm coaxial cable, which is less susceptible to interference which plugs into an F connector or Belling-Lee connector (depending on region) on the back of the TV. [6] To convert the signal from antennas that use a twin-lead line to the modern coaxial cable input, a small transformer called a balun is used in the line.

4. TV aerial plug - Wikipedia

   en.wikipedia.org/wiki/TV_aerial_plug

   Belling-Lee connectors Flex Type F connectors. A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers.

5. Cable converter box - Wikipedia

   en.wikipedia.org/wiki/Cable_Converter_Box

   Cable-ready television sets have coaxial cable F connectors. One end connects to the cable, antenna, or VHF jack on the back of the television set; the other end connects to the wall CATV outlet. Once the television is connected through the cable to the wall CATV outlet, the television will need to be programmed to receive the cable channels.

6. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...

7. Low-noise block downconverter - Wikipedia

   en.wikipedia.org/wiki/Low-noise_block_downconverter

   In the case of UK BSkyB receivers, the LNB remains powered while in standby so that the receiver can receive firmware updates and Electronic Programme Guide updates. In the United States, the LNB connected to a Dish Network receiver remains powered so the system can receive software and firmware updates and guide information over the air at night.

8. Antenna amplifier - Wikipedia

   en.wikipedia.org/wiki/Antenna_amplifier

   Antenna amplifier for broadcasting service (here: TV broadcasting and FM sound broadcasting). In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead ...

9. Wi-Fi over Coax - Wikipedia

   en.wikipedia.org/wiki/Wi-Fi_over_Coax

   Wi-Fi over Coax is a technology for extending and distributing Wi-Fi signals via coaxial cables. As an in-building wireless solution, Wi-Fi over Coax can make use of existing or new cabling with native impedance of 50 Ω shared by a Wi-Fi access point , cabling run, and antenna.