enow.com Web Search

  1. Ads

    related to: 2x4 on end vs flat edge on wall board siding material ideas pictures

Search results

  1. Results from the WOW.Com Content Network
  2. Shiplap - Wikipedia

    en.wikipedia.org/wiki/Shiplap

    Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm (3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm (3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [1]

  3. Blocking (construction) - Wikipedia

    en.wikipedia.org/wiki/Blocking_(construction)

    When correctly placed, blocking also provides grounds (also backing or back blocking) for supporting the cut ends of wall claddings and linings or for attaching items such as cabinets, shelving, handrails, vanity tops and backsplashes, towel bars, decorative mouldings, etc. Properly placed grounds make the second fixings easier once the walls ...

  4. Clapboard - Wikipedia

    en.wikipedia.org/wiki/Clapboard

    Later, the boards were radially sawn in a type of sawmill called a clapboard mill, producing vertical-grain clapboards. The more commonly used boards in New England are vertical-grain boards. Depending on the diameter of the log, cuts are made from 4 + 1 ⁄ 2 to 6 + 1 ⁄ 2 inches (110 to 170 mm) deep along the full length of the log.

  5. Siding (construction) - Wikipedia

    en.wikipedia.org/wiki/Siding_(construction)

    Siding or wall cladding is the protective material attached to the exterior side of a wall of a house or other building. Along with the roof, it forms the first line of defense against the elements, most importantly sun, rain/snow, heat and cold, thus creating a stable, more comfortable environment on the interior side.

  6. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

  7. Lumber - Wikipedia

    en.wikipedia.org/wiki/Lumber

    For example, a "2×4" board historically started out as a green, rough board actually 2 by 4 inches (51 mm × 102 mm). After drying and planing, it would be smaller by a nonstandard amount. Today, a "2×4" board starts out as something smaller than 2 inches by 4 inches and not specified by standards, and after drying and planing is minimally 1 ...

  8. American historic carpentry - Wikipedia

    en.wikipedia.org/wiki/American_historic_carpentry

    Building a palisade wall for the fort at Jamestown, Virginia The Golden Plow Tavern in York, PA, is a very unusual American building. It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America.

  9. Fiber cement siding - Wikipedia

    en.wikipedia.org/wiki/Fiber_cement_siding

    Fiber cement is a composite material made of cement reinforced with cellulose fibers. Originally, asbestos was used as the reinforcing material but, due to safety concerns, that was replaced by cellulose in the 1980s. [1] Fiber cement board may come pre-painted or pre-stained or can be done so after its installation. [2]

  1. Ads

    related to: 2x4 on end vs flat edge on wall board siding material ideas pictures