Search results
Results from the WOW.Com Content Network
The contactor or controller may include a thermostat if accurate temperature maintenance is required, or may just shut off a freeze-protection system in mild weather. Electrical heat tracing systems may be required to have earth leakage (ground fault or RCD) devices for personnel and equipment protection. The system design must minimize leakage ...
Changing the temperature by 7 to 10 degrees for eight hours a day, in winter and summer, can save about 10% a year on heating and cooling, the department said. This step to save money and energy ...
A freeze stat is a temperature sensing device for HVAC that monitors a heat exchanger to prevent its coils from freezing. Freeze stats can be used on both refrigerant -to- air , and refrigerant -to- liquid type heat exchangers and serve different purposes with similar goals for each.
A thermostat, when set to "cool", will only turn on when the ambient temperature of the surrounding room is above the set temperature. Thus, if the controlled space has a temperature normally above the desired setting when the heating/cooling system is off, it would be wise to keep the thermostat set to "cool", despite what the temperature is ...
A freeze warning is a warning issued by the National Weather Service when sub-freezing temperatures are expected in the next 36 hours. This can occur with or without frost . [ 1 ] When a freeze warning is issued in the fall , that will usually signify the end of the growing season , as sub-freezing temperatures will usually kill all remaining ...
Honeywell electronic thermostat in a store. Heating and cooling losses from a building (or any other container) become greater as the difference in temperature increases. A programmable thermostat allows reduction of these losses by allowing the temperature difference to be reduced at times when the reduced amount of heating or cooling would not be objectionable.
Freezing [1] or frost occurs when the air temperature falls below the freezing point of water (0 °C, 32 °F, 273 K). This is usually measured at the height of 1.2 metres above the ground surface. This is usually measured at the height of 1.2 metres above the ground surface.
The building balance point temperature is the outdoor air temperature when the heat gains of the building are equal to the heat losses. [1] Internal heat sources due to electric lighting, mechanical equipment, body heat, and solar radiation may offset the need for additional heating although the outdoor temperature may be below the thermostat set-point temperature.