Search results
Results from the WOW.Com Content Network
The rigging arrangements can influence the applied anchor load, where statically indeterminate systems are not necessarily a design consideration, but can be used in practice. The determination of the loads through the rigging system must be a consideration whilst calculating the load resistant model, refer to the examples shown in Figure 3.
Rigging is both a noun, the equipment, and verb, the action of designing and installing the equipment, in the preparation to move objects. A team of riggers design and install the lifting or rolling equipment needed to raise, roll, slide or lift objects such as heavy machinery, structural components, building materials, or large-scale fixtures ...
A block and tackle [1] [2] or only tackle [3] is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift heavy loads.. The pulleys are assembled to form blocks and then blocks are paired so that one is fixed and one moves with the load.
The 16 Divisions of construction, as defined by the Construction Specifications Institute (CSI)'s MasterFormat, is the most widely used standard for organizing specifications and other written information for commercial and institutional building projects in the U.S. and Canada.
1971 – OSHA passes 29 CFR 1926.550, which is the standard for cranes and derricks used in construction for the next 41 years. [3]1995 – The National Commission for the Certification of Crane Operators (NCCCO) is established by the crane and lifting industry as a nonprofit organization to develop a certification program for crane operators.
The United Kingdom began requiring construction companies, project owners, and architects to address safety and health during the design phase of projects in 1994. Australia developed the Australian National OHS Strategy 2002–2012, which set "eliminating hazards at the design stage" as one of five national priorities.
CDM 2007 was a result of an EU Directive 92/57/EEC (OJ L245, 26.8.92), [3] the 'Construction Sites Directive'. They came into force on 6 April 2007, and replaced a 1994 predecessor as amended in 2000 and 1996 Health and Safety regulations. [4]
A typical construction engineering curriculum is a mixture of engineering mechanics, engineering design, construction management and general science and mathematics. This usually leads to a Bachelor of Science degree. The B.S. degree along with some design or construction experience is sufficient for most entry-level positions.