Search results
Results from the WOW.Com Content Network
A deep-penetrating anchor (DPA) is conceptually similar to a torpedo anchor: it features a dart-shaped, thick-walled, steel cylinder with flukes attached to the upper section of the anchor. A full-scale DPA is approximately 15 metres (49 ft) in length, 1.2 metres (4 ft) in diameter, and weighs on the order of 50–100 tonnes (49–98 long tons ...
Anchor channels, invented by Anders Jordahl in 1913, are steel channels cast flush in reinforced concrete elements to allow the installation of channel bolts for the fastening of components. Anchor channels consist of steel C-shaped channels and anchors (mostly headed studs ) which are connected to the channel by welding or riveting/forging.
In past decades attempts to protect concrete have included sealers ranging from wax to linseed oil. Today, high quality concrete sealers can block up to 99% of surface moisture. There are two main sealer categories: topical sealers (coatings) and penetrating sealers (reactive).
Bonded anchors are also referred as adhesive anchors [9] or chemical anchors. The anchoring material is an adhesive (also called mortar) [3] usually consisting of epoxy, polyester, or vinylester resins. [1] In bonded anchors, the force-transfer mechanism is based on bond stresses provided by binding organic materials.
Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.
Minwax was founded in 1904 by Arthur B Harrison. Harrison persuaded his employer at Clifford I. Miller to manufacture a line of waterproofing materials, and later bought the line in 1910, [2] which he then named Minwax®. [3]
Single helix earth anchors Guyed mast anchor. An earth anchor is a device designed to support structures, most commonly used in geotechnical and construction applications. Also known as a ground anchor, percussion driven earth anchor or mechanical anchor, it may be impact driven into the ground or run in spirally, depending on its design and intended force-resistance characteristics.
This is particularly important for light, modern anchors designed to bury in the bottom, where scopes of 5:1 to 7:1 are common, whereas heavy anchors and moorings can use a scope of 3:1, or less. Some modern anchors, such as the Ultra holds with a scope of 3:1; [ citation needed ] but, unless the anchorage is crowded, a longer scope always ...